Creating and Applying a Prep Modifier
An intuitive step-by-step guide on creating and applying a Prep Modifier.
To reach this screen, from the Main Focus Login, choose the 'Wrench' Icon on the log-in Keypad.
Once the 'Wrench' icon is chosen, select 'Setup'. This will prompt you to log-in.
NOTE: Your must have access to the 'Setup' screen in order to log in.
On the Setup page, select the miscellaneous tab located at the top of the page, then select 'General'
In the Misc > General page, select the 'Prep Modifiers' tab. (Arrow 1)
In Prep Modifiers, you may name your new modifier, or change the name of an existing modifierunder 'Command Name' (Arrow 2).
Afterwards, you may choose to select an 'Image' to use. This is entirely optional. (Arrow 3).
Save, then close the Misc > General page. (Arrow 3)
On the setup page, select 'Canvases' located at the top of the page.
On the Canvases page, select the canvas you would like to add the Prep Modifier to.
Once on this page, you may right-click or hit 'Add' on the Canvas Inspector, then add a 'Command' button. (Arrow 1)
Set the 'Item' of the command button to either Prep Mod 1, 2, or 3. (Arrow 2)
Proceed to the canvas properties located at the top of the Canvas Inspector. (Arrow 3)
On the Canvas Properties, you may allocate any Prep Modifiers that you have created using the 'Prep Modifiers Commands' drop-down menus. (Arrow 1)
Select 'Save' and close the page. (Arrow 2)
Comments
0 comments
Please sign in to leave a comment.